Note: The Hacker/Tweaker is a bare PCB board, you will need to make your own case. It powers up right from the Zt-3 DATA port. There are two mounting holes for screws or standoffs. Like all LED displays it requires a tinted foil or Lexan cover.
Designed to fit into tight spots, full board dimensions are less than 2" by 1". The Zeitronix Hacker/Tweaker is a very small AFR or Lambda display for the Zt-3 Wideband Systems.
Purchase this item to gain access in the Woolich Racing Tuned software to the stock bin files for the 2015-2017 Yamaha MT-09 Tracerįeatures available for Yamaha FJ-09 / MT-09 Tracer 2015-2017 You must have a Race Tool Package to use the Pit Speed Limiter Harness.īin File Definitions - for use in Woolich Racing Tuned softwareĢ015-2017 Yamaha MT-09 Tracer Stock Bin File Definitions The Pit Speed Limiter harness is used with our Race Tools Package, it consists of a harness and water proof push button switch which allows you to limit the RPM of the bike in 1st gear while riding in the pits.
If you do not have a Woolich Racing Interface you can also visit a Woolich Racing - Tuning Partner and have them install and configure the Race Tools (additional fees and charges will apply). You can purchase this as a package on the product page for your bike. You will need to use the relevant Woolich Racing Interface and Bin File Definition to enable and configure Race Tools and write to the ECU. Woolich Racing Race Tools requires you to Write the ECU. *** The Pit Speed Limiter / Engine Warm Up requires the purchase of an additional Pit Speed Limiter harness. ** This harness uses the stock O2 Sensor plugs on the bike's harness, the stock O2 sensor should be removed from the bike and disabled in the WRT software. * Contact us after ordering if you have after-market rearsets or are using a race shift pattern and we will swap the shift rod for a generic rod that can be cut and tapped to the correct length. Pit Speed Limiter RPM can be configured.***Įngine Warm Up parameters are configurable.*** Launch Control allows you to configure Delay, Launch RPM and Hold Speed. Quickshifter Kill times are configurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations.Īutoblipper Opening and Duration maps are fully configurable per gear. Race Tools Key to allow the use of the Race Tools on one ECU in the Woolich Racing Tuned software.Yamaha Race Tools Type 2 which allows the quickshifter to be plugged into the bikes wiring harness**.Shift rod for standard shift configuration*.High quality dual direction strain gauge Quickshifter with digitally controlled pressure sensing that can be used in regular or race shift pattern.The Race Tools package allows you to enable Autoblipper, Quickshifter, Engine Warm Up, Pit Speed Limiter and Launch Control in the Stock ECU.
Race Tools: Quickshifter, Launch Control, Pit Speed Limiter